Thermoplastic - Worbla ® Worbla's Meshed Art Heat Activated Molding Material (Price per Sheet)

Out of stock
Add to wishlist

Worbla's Black Art ® (Worbla for short) Thermoplastic is a unique molding material which initially resembles stiff plastic sheeting. It is great for masks, costumes, millinery, castings & hand molded sculptural pieces. When heated it becomes soft, allowing it to be molded and shaped by hand or on a mold or block. Once cooled it retains the molded shape. This process of heating and cooling can be repeated until the desired shape is acquired. Worbla's Mesh art additionally contains a reinforcing mesh scrim, making it much stronger and resistant to tearing once heated and cooled. The sheen side contains glue and will adhere to other worbla sheets when heated. The sheets can be finished with paint/sprays/etc but it is recommended that the surface be sanded before any finishes/paints are applied.

Product Measurements

The sheets are approximately 1.5mm thick and sold in units of 37.5 x 25cm (1/16 of a full sheet). Please note that we will supply a continuous sheet if more than one quantity is purchased. Refer to the table below for sizing and pricing information.

SizeDimensionsOrder QTYPrice
1/16th Sheet37.5cm x 25cm1$14.90
1/8th Sheet37.5cm x 50cm2$27.90
Quarter Sheet75cm x 50cm4$41.88
Half Sheet75cm x 100cm8$65.92
Full Sheet150cm x 100cm16$115.84
If other colours are available for this product, these are listed in the table below. Please note colour variations may occur especially on naturally occurring products and those that have been dyed. We try our best to ensure colour consistency but cannot guarantee that two different products with the same colour description will have the same colour.
More information can be obtained from Worbla ®.