Thermoplastic - HatBondCM Heat Activated Molding Material
SKUAdd to wishlist
HatBondCM is a unique molding material specifically designed for the millinery, fashion and theatrical industries. It is great for masks, costumes, millinery, castings & hand molded sculptural pieces. When heated it becomes very sticky, allowing it to bond to a variety of fabrics on both sides, and soft, allowing it to be molded and shaped by hand or on a mold or block. Once cooled it retains the molded shape and becomes almost invisible between bonded materials (including fabric, straws and leather). This process of heating and cooling can be repeated until the desired shape is acquired.
The sheets are approximately 0.3mm thick and sold in units of 50 x 70cm (1/4 of a full sheet). Please note that we will supply a continuous sheet if more than one quantity is purchased. Refer to the table below for sizing and pricing information.
|Quarter Sheet||50 x 70cm||1||$19.90|
|Half Sheet||100 x 70cm||2||$39.80|
|Full Sheet||100 x 140cm||4||$79.60|
If other colours are available for this product, these are listed in the table below. Please note colour variations may occur especially on naturally occurring products and those that have been dyed. We try our best to ensure colour consistency but cannot guarantee that two different products with the same colour description will have the same colour.